Monday, March 24, 2014

2007 Suzuki Forenza 2.0, Rough Running Engine and Overheating Issues


This 2007 Suzuki Forenza with a 2.0 came into the shop a couple of months ago with a customer concern of a rough running engine and an overheating issue. We felt pretty confident we were looking at a blown cylinder head gasket at this point; but, we wanted to "test and not guess".

There are a couple of ways to check for a blown cylinder head gasket. One way is to pressurize the coolant system and, with the spark plug out of the missing cylinder (or all plugs removed), using a bore scope in the cylinders to check for seeping coolant. Another way is to use a 5-Gas Analyzer to check for combustion gases in the coolant system. The third option, similar to the second, is to do what is called a block test.

We opted for the third option. It is a method we have used often with great success.

Before this, however, we wanted to perform a visual inspection.

When the customer drove the vehicle up to the shop, we noticed the tell-tale white smoke out the tail pipe. It was quite pronounced and the smell of coolant in the exhaust was noticeable.


The next visual inspection was of the oil. As you can see in the pictures below, the milky look to the oil is a sure sign that coolant has entered the crankcase.



We let the vehicle sit and then took the cap off the coolant tank. We noticed when we started it, fumes coming out of the tank.


Per the instructions with the block test kit, we let the vehicle run for about ten minutes and then performed the test. The kit comes with a clear tube and a fluid. The fluid is added to the tube, then you place the tube over the coolant tank opening. You apply vacuum to the top of the tube, in this case we used a hand-held vacuum pump, and apply vacuum for a minute or two. If combustion gases are present in the coolant, which they should not be, then it confirms a problem. (If there is a problem, the fluid, which is blue out of the bottle, will turn green.) Of course, it could be a blown head gasket, a cracked head . . . etc., but you confirm there is a problem that calls for a top-end engine tear down.

In the picture below, you see the fluid just added to the tube. You can see it is a light blue color out of the bottle. If the test passes (meaning no combustion gases are detected in the coolant system; hence, no blown head gasket) the fluid will remain blue. However, if the test fails, (combustion gases detected) then it will turn green within a minute or two.


Here I am showing (minus the fluid) how the tube fits on the coolant tank. (It is minus fluid because I just took the picture to demonstrate how to do it.)


As I applied vacuum (via the vacuum pump) to the top of the tube, within seconds, the blue fluid changed to green. This confirmed a failure at the mating of the head and block. Now, it was time to remove the head, send it to the machine shop and replace the head gasket.


We replaced the head gasket, timing belt and water pump and other odds and ends. Put it all back together and the vehicle ran nice and smooth. We test drove it a few miles and shipped it to the customer.

3 comments:

  1. I have the same issues with my 2007 suzuki forenza, can I please have your contacts and address to also check my car?

    ReplyDelete
  2. Estimated cost? Think I have similar issue

    ReplyDelete
    Replies
    1. As for an estimate, it really depends on where you live. Labor rates and parts markup are different depending on your location. One site that can help with this is Repairpal.com. You simply enter your vehicle info and your zip and it will give you a price of what to expect for your area. If you are outside the USA, I'm not sure if Repairpal has an international site or not; but, I'm sure there would be a similar site to assist you with it.

      Delete